【单选题】
Excuse me, sir, would you please ( ) your mobile phone?___
A. turn on
B. turn to
C. turn in
D. turn off
查看试卷,进入试卷练习
微信扫一扫,开始刷题

答案
D
解析
暂无解析
相关试题
【单选题】
The computer must be switched off when the seat belt signs ( ) during the landing time.___
A. come in
B. come to
C. come off
D. come on
【单选题】
The mobile phone is prohibited to use on the plane. It might ( ) the plane's navigation system. ___
A. interfere on
B. interfere in
C. interfere with
D. interfere to
【单选题】
Which of the following means different from the other choices?___
A. The headsets don't work.
B. The headsets are out of use.
C. The headsets are out of function.
D. The headsets are in good condition.
【单选题】
Could you please tell me ( )? ___
A. where the airport is
B. how far the airport was
C. how can we get to the airport built
【单选题】
He looked out of the window and saw a group of children ( )football. ___
A. to play
B. played
C. playing
D. play the
【单选题】
They were short of money and couldn't ( ) the project.___
A. went on with
B. went on doing
C. go on with
D. go on to do
【单选题】
There are many books in our school library, but( )of them is written in Russian.___
A. some
B. all
C. both
D. none
【单选题】
Be quiet! I have( ) to tell you.___
A. something important
B. anything important
C. important something
D. important something
【单选题】
"What do we do now?" Peter said in a low voice. The underlined part means ( ). ___
A. damaged
B. shouted
C. attracted
D. whispered
【单选题】
Sorry, Sir. I completely understand ( ) you feel, but we don’t have pills for coldness on board. ___
A. which
B. what
C. that
D. how
【单选题】
You may refer to ( ) at any time for fly information. ___
A. the music
B. the videos
C. the movies
D. the Air-show
【判断题】
Electronic devices may interfere with the aircraft navigation system during take-off and landing.
A. 对
B. 错
【单选题】
城市轨道交通运营单位承担运营安全风险分级管控和隐患排查治理工作 ,逐级分解责任,确保责任落实到部门和岗位。___
A. 主体责任
B. 部分责任
C. 同等责任
D. 一定责任
【单选题】
城市轨道交通运营安全风险等级从高到低划分为 四个等级。___
A. 重大、较大、一般、较小
B. 特别重大、重大、较大、一般
C. 特别重大、重大、较大、较小
D. 重大、较大、较小、轻微
推荐试题
【单选题】
在处理CRH380A统型动车组制动不足故障时,( )不可能用到。 ___
A. 紧急复位操作
B. 切除车辆制动系统
C. 配电盘紧急制动NFB、制动控制装置NFB断开
D. 牵引变流器1断开
【单选题】
CRH2A统型动车组二级修车体倾斜(高度差)允许值:前后两端<( ),左右两侧<( ),对角<( )。___
A. 25mm.15mm.15mm
B. 25mm.15mm.25mm
C. 15mm.25mm.25mm
【单选题】
CRH2A统型动车组二级修时,将( )旋钮右旋,并一直保持,监控显示器显示各车【压】状态,对各车门压紧状态进行确认。 ___
A. 车门锁紧
B. 门手控集控开关
C. 空档
D. 停放
【单选题】
CRH2A统型动车组二级修,自动打开头罩的方法:进入司机室,投入主控,闭合司机室配电 盘内【联解控制】空开后,按下( )按钮。___
A. 联挂
B. 解联
C. 实验
D. 强制罩开
【单选题】
CRH2A统型动车组01车关闭头罩的方法:①然后按压[解联]按钮②头罩关闭,再恢复[试验]按钮 ③按压边柜内【试验】按钮( )___
A. ①②③
B. ②①③
C. ①③②
【单选题】
CRH2A统型动车组二级修 ,过渡车钩检查及润滑,用干布、毛刷清理车钩连接面、钩舌和钩舌腔,去除杂物,在钩舌和钩舌腔表面涂抹( );转动钩舌,确认钩舌动作良好。___
A. 润滑脂
B. 二流化碳
C. 松动剂
【单选题】
CRH2A统型动车组二级修,轮对内侧距测量时,用( )测量轮对内侧距,测量时应将内 测距尺可靠贴紧轮辋内侧及轮缘上方,到位后,及时锁紧游标尺,取下读取数据。___
A. 第四号检查器
B. 轮对内测距尺
C. 卷尺
【单选题】
CRH2A统型动车组二级修,轮对 内侧距测量时,任意三点内侧距测量均应( )范围。___
A. 1350~1355mm
B. 1352~1355mm
C. 1352~1356mm
【单选题】
CRH2A统型动车组二级修,安装磁性栓及排油栓座时,使用扭力扳手进行紧固,扭矩:( )质检确认后, 使用低碳铁丝φ1.2-L防松紧固,打好防松标记。___
A. 95N·m,
B. 98N·m,
C. 108N·m,
D. 127N·m,
【单选题】
CRH2A统型动车组二级修,检查受电弓控制 阀板及相关配件时,升弓状态下压力表显示压力值约( )。___
A. 210-2600KPA
B. 250-320KPA
C. 310-350KPA
D. 330-360 KPA
【单选题】
CRH2A统型车轮踏面擦 伤(车轮直径>840mm)一级检修限度是( )。___
A. 长度≤20mm 深度≤0.25mm
B. 长度≤25mm 深度≤0.25mm
C. 长度≤30mm 深度≤0.25mm
D. 长度≤35mm 深度≤0.25mm
【单选题】
CRH2A统型车轮踏面 擦伤(车轮直径≤840mm)一级检修限度是( )。___
A. 长度≤20mm 深度≤0.25mm
B. 长度≤25mm 深度≤0.25mm
C. 长度≤30mm 深度≤0.25mm
D. 长度≤35mm 深度≤0.25mm
【单选题】
CRH2A统型动车组牵引 中心销与横向挡距离一级检修限度是( )。___
A. 18mm-20mm
B. 18mm-22mm
C. 20mm-21mm
D. 20mm-22mm
【单选题】
将停放制动旋钮镟至“施加 ”位,确认“紧急制动”灯亮,右旋转换开关盘上的( ),确认“紧急制动”灯亮灭。___
A. 停放
B. 停放缓解紧急
C. 车门锁紧
D. 电制动切除
【单选题】
CRH2A统型动车组有电作业制动试验,进入监控显示器BC压力画面,操作制动手柄,分别置于( )。___
A. 1N、4N、7N、EB位
B. 1N、2N、3N、EB位
C. 1N、3N、7N、EB位
D. 1N、4N、7N、运行位
【单选题】
CRH2A统型动车组一级检修作业中,3号位负责车体( )检查;4号位负责车体( )检查。___
A. 1位侧,2位侧
B. 2位侧.1位侧
C. 1位侧,1位侧
D. 2位侧,2位侧
【单选题】
CRH2A统型动车组二级修,车体倾斜(高度差)允许值:前后两端<( ),左右两侧<( ),对角<( )。___
A. 25mm.15mm.15mm
B. 25mm.15mm.25mm
C. 15mm.25mm.25mm
【单选题】
CRH2A统型动车组二级修,将( )旋钮右旋,并一直保持,监控显示器显示各车【压】状态,对各车门压紧状态进行确认。 ___
A. 车门锁紧
B. 门手控集控开关
C. 空档
D. 停放
【单选题】
CRH2A统型动车组二级修,自动打开头罩的方法是:进入司机室,投入主控,闭合司机室配电 盘内【联解控制】空开后,按下( )按钮。___
A. 联挂
B. 解联
C. 实验
D. 强制罩开
【单选题】
CRH2A统型动车组二级修,过渡车钩检查及润滑方法,用干布、毛刷清理车钩连接面、钩舌和钩 舌腔,去除杂物,在钩舌和钩舌腔表面涂抹( );转动钩舌,确认钩舌动作良好。___
A. 润滑脂
B. 二流化碳
C. 松动剂